JANOME 2222 Instruction Booklet download pdf (Page 24)

Threading the Machine

Raise the take–up lever to its highest position by

turning the handwheel toward you.

Raise the presser foot.

Place a spool on the spool pin as shown, with

thread coming from back of the spool.

z Draw the thread into thread guide using both

hands.

x While holding the thread near spool, draw

thread down into the tension area and then

around the check spring holder.

c Firmly draw the thread up and through the

take–up lever from right to left.

v Then draw the thread down and slip it into the

lower thread guide.

b Draw the thread down and slip it into needle

bar thread guide on the left.

n Thread the needle eye from front to back.

Needle threader

z Raise the needle to its highest position. Push

down the needle threader knob q as far as it

will go.

The hook comes out through the needle eye

from behind.

x Paying close attention to the needle point,

draw the thread around the guide e and

under the hook w.

c Release the knob slowly while holding the

thread end r with your hand. A loop of the

thread is pulled up through the needle eye.

q Knob

w Hook

e Guide

r Thread end

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 63 64

No comments

JANOME 2222 Instruction Booklet Page 24