JANOME 2222 Instruction Booklet download pdf (Page 22)

Winding the Bobbin

z Pull the handwheel out.

x Draw the thread from spool.

Guide the thread around the bobbin winder

thread guide.

c Insert the thread through the hole in the

bobbin from the inside to the outside.

Put the bobbin on the bobbin winder spindle.

v Push it to the right.

b With the free end of the thread held in your

hand, depress the foot control.

Stop the machine when it has made a few turns,

and cut the thread close to the hole in the

bobbin.

n Depress the foot control again.

When the bobbin is fully wound, stop the

machine.

Return the bobbin winder spindle to its original

position by moving the spindle to the left, and

cut the thread.

m Push the handwheel to the left. (original

position).

Note:

Return the bobbin winder spindle when the

machine stops.

• Inserting bobbin

z Place a bobbin in the bobbin case, making

sure the thread feeds clockwise from the

bobbin.

x Draw the thread through the slot of the case.

c Continue to draw the thread under the tension

spring and through the opening.

Pull out about 4˝ (10 cm) of thread.

q Tension spring

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 63 64

No comments

JANOME 2222 Instruction Booklet Page 22