JANOME DC4030PR Instruction Booklet download pdf (Page 27)

t Mark for placement of buttonhole

y Starting point

u Slider

i There should be no gap.

o Stopper

!0 Difference

c Raise the foot. Insert needle thread through slot in foot.

Draw both threads to left under the foot. Insert the fabric

under the foot, and lower the needle into the fabric at

the buttonhole starting point. Lower the buttonhole foot.

If there is a gap i, it may cause an uneven buttonhole

stitch length as shown !0.

• Starting to sew

z Start the machine to sew the buttonhole.

The buttonhole will sew a buttonhole in the following

order:

a Step 1 and 2: Front bartack and left row.

s Step 3: Right row..

d Step 4: Back bartack and locking stitches at the

end.

f Indicator window shows each sewing step and a

dot will blink when the buttonhole is finished.

If you select the other pattern without raising the foot, the

indicator window shows “UP” to warn you.

x Remove the fabric and place a pin just before the

bartack at each end, to prevent cutting bartacks. Cut

the opening with the buttonhole opener. Use an awl

to open the keyhole buttonhole.

c When finished, push the buttonhole lever up as far as

it will go.

If you start sewing the buttonhole without lowering the

buttonhole lever, the indicator will show a warning sign.

Lower the buttonhole lever, then restart the machine.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 43 44

No comments

JANOME DC4030PR Instruction Booklet Page 27