JANOME DC4030PR Instruction Booklet download pdf (Page 15)

Threading the Machine

• Threading the machine

q Up/down needle position button

w Spool

* Raise the thread take-up lever to its highest position.

* Raise the presser foot lifter.

* Place a spool on the spool pin, with the thread coming

off as shown.

z Draw the end of the thread around the upper thread

guide.

x While holding the thread near the spool w, draw the

end of the thread down around the check spring holder.

c Firmly draw the thread up from right to left over the

take-up lever, and down into the take-up lever eye.

v Pass the thread through the lower thread guide. Slide

the thread behind the needle bar thread guide on the

left. Thread the needle from front to back, or use a

needle threader.

NOTE:

The needle threader can be used with a #11 to #16

needle or a blue tipped needle. Thread size 50 to 90

should also work well.

Needle Threader

q Knob

w Hook

e Guide (a)

r Guide (b)

t Holder plate

z Lower the presser foot. Raise the needle to its highest

position. Pull down the needle threader knob q as far

as it will go. The hook comes out through the needle

eye from behind.

x Draw the thread from guide (a) e to guide (b) r and

under the hook w. Draw the thread up along the right

side of the guide (b) r and slip the thread in between

the guide (b) and the holder plate t.

c Raise the knob in the direction of the arrow on the

illustration, drawing the thread loop through the

needle.

v Pull the thread through the needle eye.

CAUTION:

Turn off the power switch when using the needle

threader.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

Comments to this Manuals

No comments

JANOME DC4030PR Instruction Booklet Page 15

Comments to this Manuals

Related products and manuals for Sewing machines JANOME DC4030PR