JANOME DC4030PR Instruction Booklet download pdf (Page 19)

Using the Seam Guides on the Needle Plate

q Needle drop position

w Edge of fabric

e Seam guides

The seam guides on the needle plate are engraved to

help you measure seam width. The numbers on the

needle plate indicate the distance between the center

needle position and the edge of the fabric. The lines are

1/8˝ (0.3 cm) apart, and engraved at 3/8˝, 4/8˝, 5/8˝ and

6/8˝. The lines in millimeters are 5 mm apart, and are

engraved at 10 mm, 15 mm and 20 mm.

Turn a Square Corner

q Cornering guide

w Up/down needle position button

e Presser foot lifter

Tur ning a square corner 5/8˝ (1.6cm) from the fabric

edge. Stop stitching and lower needle down into the fabric

by pressing the Up/Down needle position button when

the fabric edge facing you lines up with the cornering

guide as shown.

Raise the presser foot and turn the fabric to line up the

edge with the 5/8˝ (1.6cm) seam guide.

Lower the presser foot and begin stitching in the new

direction.

qwe

Quilting

q Stitch pattern:

w Needle thread tension: A

e Presser foot: Zigzag foot: A

r Quilter

Use the seam guide lines on the needle plate, and the

free-arm, to help determine the distance between quilting

stitches. The quilter will help keep the stitching line

straight.

z Loosen the quilter holding screw.

Slide the quilter in the hole to the desired width and

tighten the screw.

x Sew, guiding the quilter over the previous row of

stitching.

q Quilter holding screw

w Quilter

e Hole

r Distance

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Comments to this Manuals

No comments

JANOME DC4030PR Instruction Booklet Page 19

Comments to this Manuals

Related products and manuals for Sewing machines JANOME DC4030PR