JANOME DC4030PR Instruction Booklet download pdf (Page 34)

qwe

Bartacking

q Stitch pattern:

w Thread tension dial: A

e Presser foot: Satin stitch foot: F

Tacking is used to reinforce pockets, crotches and belt

carriers where extra stretch is needed.

The machine will sew a tacking of 1.5 cm (5/8˝) q length

automatically.

The dot r will blink when the bartacking is finished, and

the machine will memorize the tack length.

To sew another tack in the same size, simply restart the

machine and it will stop automatically when finished

sewing.

To change the tack length, press the stitch pattern

selection key. The blinking dot will disappear.

q 1.5 cm (5/8˝)

w Start point

e End point

r Dot

• To sew a shorter tack

When you sew a tack less than 1.5 cm (5/8˝) in length,

sew to the required length t and press the reverse

button y. The machine will memorize the tack length u.

t Required length

y Reverse button

u Tack length

i Starting point

• Adjusting the evenness of bartacking

Make a test on an extra piece of fabric to check your

settings. If the bartacking is uneven, adjust the stitch

by turning the feed balancing dial !1 as follows.

• Stitch does not meet start position o. Turn dial toward

“+” for even stitch.

• Stitch does not meet return position !0. Tu rn dial toward

“–” for even stitch.

o Start position

!0 Return position

!1 Feed balancing dial

!2 Standard setting mark

!3 Indication line

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

No comments

JANOME DC4030PR Instruction Booklet Page 34