JANOME DC4030PR Instruction Booklet download pdf (Page 33)

• Fine-tuning the needle drop position

The needle drop position can be adjusted by pressing

stitch width adjusting button.

(1) Press the minus (–) key to move the needle drop

position to the right.

(2) Press the plus (+) key to move the needle drop

position to the left.

r Guide

t Left needle drop position

NOTE:

The needle drop position will move to the left or right,

but the stitch width is remained the same.

(1)

(2)

q Stitch pattern:

w Thread tension dial: A

e Presser foot: Blind hem foot: G

(1) (2)

qwe

z Fold a hem with the wrong side of the fabric up to

form a 0.4 – 0.7 cm allowance.

q Wrong side of fabric

w 0.4 – 0.7 cm

(1) Fold the hem under the fabric for lightweight

fabrics.

(2) On heavyweight fabrics that tend to ravel, the

raw edge should be overcast first.

x Place the fabric so that the needle just pierces the

folded edge when the needle comes over the

extreme left side. Lower the presser foot.

c Turn the guide screw to adjust the position of the

guide to match it with the folded edge. Sew

guiding the folded edge along the guide.

e Guide screw

r Guide

t Folded edge

v Open the fabric after sewing is finished.

y Right side of the fabric

Blind Hemming

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 43 44

No comments

JANOME DC4030PR Instruction Booklet Page 33