JANOME HD1000 Instruction Booklet download pdf (Page 44)

38

Buttonhole

q Pattern selector: A ( )

w Presser foot: Buttonhole foot

e Thread tension: 2–6

r Stitch length: 0.5-1

To adjust buttonhole stitch density:

Set the stitch length dial between 0.5 and 1.0 to

adjust the buttonhole stitch density.

z Carefully mark buttonhole length on fabric.

Place the fabric under the foot with the

buttonhole marking running toward you.

x Slide both threads to the left.

Line up the foot with the top mark on the

fabric. Lower the needle into the fabric

where the buttonhole is to start, and lower the

foot.

c Set the pattern selector dial at “ ”.

Sew forward until you reach the front marking

of your buttonhole.

Stop sewing at a left stitch.

v Set the pattern selector dial at “ ”.

Sew 4 to 6 stitches. Stop sewing at a right

stitch.

b Set the pattern selector dial at “ ”.

Sew until you reach the back marking of the

buttonhole.

Stop sewing at a right stitch.

n Set the pattern selector dial at “ ”.

Sew a few bartacks and raise the needle from

the fabric.

Set the stitch length dial to “0” and the pattern

selector dial at straight sewing.

Sew a few locking stitches.

m Remove the fabric from the machine and cut

the sewing thread. Insert a pin inside the

bartack. Then cut the opening with a seam

ripper.

Ta ke care not to cut the stitches.

qwe

r

cvb n

m

z x

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 71 72

Comments to this Manuals

No comments