JANOME 8002D Instruction Booklet download pdf (Page 37)

Replacing the Upper Knife

To remove:

Turn off the power switch and unplug the machine.

2. Open the looper cover and side cover.

3. Deactivate the upper knife.

4. Remove the hexagonal bolt, and remove the

upper knife.

Upper knife

2 Hexagonal bolt

3 Stopper pin

4 Lower knife

To attach:

1. Insert new upper knife into the groove of knife

holder and stopper pin, then tighten the

hexagonal bolt slightly.

2. Turn the upper knife holder to cutting position.

3. Turn the handwheel toward you until the upper

knife comes to its lowest position.

Loosen the hexagonal bolt, and adjust the

position of the upper knife so that the edge of the

upper knife overlaps 0.8 to 1.5 mm (3/64´´) from

the edge of lower knife as illustrated.

Then tighten the hexagonal bolt firmly.

4. Close the looper cover and side cover.

Cleaning Upper Knife Area

Turn off the power switch and unplug the machine.

2. Open the looper cover.

Remove the waste pieces to the front with a lint

brush or waste scraps.

* You may use a vacuum cleaner to clean the upper

knife area or feed dog.

* The lower knife will last over one year in normal

use. However, if you run over a pin or a hard

object, it may be required to replace both upper

and lower knives at the same time.

CARE OF YOUR MACHINE

0.8 ~ 1.5 mm (3/64˝)

1 2 ... 32 33 34 35 36 37 38 39 40 41 42

No comments

JANOME 8002D Instruction Booklet Page 37