JANOME 8002D Instruction Booklet download pdf (Page 15)

Threading the Machine

The left illustration shows the completed threading

conditions of four threads.

Lower looper thread

2 Upper looper thread

3 Right needle thread

4 Left needle thread

5 Thread guide

6 Thread guide plate

7 Threading chart

The machine is pre-threaded to make threading

easier.

Tie the end of a new thread to one of the pre-set

threads, and pull it to draw the new thread through

the machine, following the steps below.

Turn off the power switch before threading the

machine.

1. Pull the threads from the spools and draw them

through the thread guides, then tie the thread

ends together.

2. Raise the presser foot, draw the threads until the

knots are coming out from under the back of the

presser foot.

3. However, stop drawing the needle threads when

the knots reach just before the needle eye.

Cut the knots and thread the needle eye.

4. Before starting sewing, clear the needle threads

from under the presser foot to make sure they are

not caught below the needle plate.

(Draw the needle threads in the direction A)

Then pull out the threads to the back approxi-

mately 10 cm (4˝) away from the presser foot.

Lower the presser foot, and you are now ready to

sew.

Thread guide

2 Needle

3 Needle thread

4 Presser foot

5 Needle plate

• For re-threading the machine easily, start from the

lower looper, upper looper, right needle and left

needle threads.

Make sure to clear the needle threads out from

below the needle plate and draw them to the

back and under the presser foot about 10 cm (4˝).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 41 42

Comments to this Manuals

No comments

JANOME 8002D Instruction Booklet Page 15

Comments to this Manuals

Related products and manuals for Sewing machines JANOME 8002D