JANOME Horizon Memory Craft 8200 QC Instruction Booklet download pdf (Page 28)

Needle stop position setting

The machine always stops with the needle in the down

position except when sewing buttonholes, specialty

stitches, monograms, etc. However you can select the

needle stop position to up or down.

Enter the setting mode. Press the mode key to enter the

needle stop position setting.

The default needle stop position setting is down position

“dn”.

To change the needle stop position, press the cursor

key “ ” and the “UP” mark will blink.

Start-up speed setting

The machine will start running slowly and the sewing

speed will gradually increase to maximum when pressing

the start/stop button.

Youcanselectthedesiredstart-upspeedfrom1(slow)q,

2 (medium) w or 3 (high) e.

Enter the setting mode. Press the mode key twice to

enter the start-up speed setting.

The default start-up speed setting is “1” (slow). To change

the start-up speed, press the cursor key “ ” or

“ ”, and the selected speed number will blink.

Resetting all to default

The following customized settings can be reset to the

original settings (factory settings).

•Buzzersound

•Needlestopposition

•Startupspeedsetting

Enter the setting mode. Press the mode key 3 times to

enter the Resetting all to default mode.

Press and hold the clear key until the machine beeps to

reset the machine to the factory default setting.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 91 92

No comments

JANOME Horizon Memory Craft 8200 QC Instruction Booklet Page 28