JANOME Horizon Memory Craft 8200 QC Instruction Booklet download pdf (Page 23)

Threading the Machine

Raise the presser foot lifter to raise the presser foot.

Turn the power switch on.

Press the needle up/down button to raise the take-up lever

to the highest position.

Press the lockout key or turn the power switch off.

Pass the thread in the order from

CAUTION:

Always make sure to press the lockout key to lockout

the machine or turn the power switch off before

threading the machine.

b n m

z Hold the thread with both hands and pass the thread

into the guide slot.

q Guide slot

x Hold the thread with both hands and draw the thread

around the corner of the guide.

Firmly pull the thread toward you along the right

channel until the thread snaps.

w Corner of the guide

e Right channel

c Draw the thread down along the right channel and

around the bottom of the thread guide plate. Pull the

thread up along the left channel.

e Right channel

r Thread guide plate

t Left channel

v While holding the thread at the spool, ﬁrmly draw the

thread up and to the back of the take-up lever. Draw

the thread forward to slip it into the eye of the take-up

lever.

y Eye of the take-up lever

b Then pull the thread down along the left channel and

through the lower thread guide.

u Lower thread guide

n Slide the thread behind the needle bar thread guide

on the left.

i Needle bar thread guide

m Thread the needle with the needle threader (refer to

the next page).

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 91 92

No comments

JANOME Horizon Memory Craft 8200 QC Instruction Booklet Page 23