JANOME Horizon Memory Craft 8200 QC Instruction Booklet download pdf (Page 9)

Machine Operating Buttons

q Start/stop button

Press this button to start or stop the machine.

The machine starts running slowly for the ﬁrst few

stitches, it then runs at the speed set by the speed control

slider. The machine runs slowly as long as this button is

pressed.

The button will turn red when the machine is running, and

green when it has been stopped.

Pressing and holding this button while sewing will slow

down the sewing speed and the machine will stop when

the button is released.

NOTES:

•Thestart/stopbuttoncannotbeusedwhenthefoot

control is connected to the machine.

•Themachinewillnotrunandthepresserfootmark

y will blink if you start the presser foot in the up

position. Lower the presser foot and press the start/

stop button.

•Youcanselectthedesiredstart-upspeedfrom

slow, medium or high (refer to page 26).

w Reverse button

When sewing stitch pattern 1, 4, 6, 7, 8, 1S, 4S (mode 1),

01, 04, 08, 09, 10 (mode 2) or 01, 02, 03, 46, 47 (mode

3), the machine will sew in reverse as long as the reverse

button is pressed.

If stitch pattern 1, 4, 6, 7, 8, 1S, 4S (mode 1), 01, 04,

08, 09, 10 (mode 2) or 01, 02, 03, 46, 47 (mode 3), has

been selected and the foot control is not connected,

the machine will start sewing in reverse as long as the

reverse button is pressed.

If you press the reverse button when sewing any other

patterns, the machine will immediately sew locking

stitches and automatically stop.

e Auto-lock button

When sewing stitch pattern 1, 4, 6, 7, 8, 1S, 4S (mode 1),

01, 04, 08, 09, 10 (mode 2) or 01, 02, 03, 46, 47 (mode

3), the machine will immediately sew locking stitches and

automatically stop when the auto-lock button is pressed.

When sewing all other patterns, the machine will sew to

the end of the current pattern, sew locking stitches and

stop automatically.

The machine will trim the threads automatically after

locking the stitch when the auto thread cutting option is

turned on.

r Needle up/down button

Press this button to bring the needle bar up or down.

The machine will stop with the needle in down position.

However, you can change the needle stop position in the

setting mode (refer to page 26).

t Thread cutter button

Press this button when you ﬁnish sewing to trim the

threads. The needle bar automatically rises after trimming

the threads (refer to page 29).

NOTE:

Use the thread cutter on the face cover if the thread is

#30 or thicker (refer to page 29).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 91 92

Comments to this Manuals

No comments

JANOME Horizon Memory Craft 8200 QC Instruction Booklet Page 9

Comments to this Manuals

Related products and manuals for Sewing machines JANOME Horizon Memory Craft 8200 QC