JANOME Horizon Memory Craft 8200 QC Instruction Booklet download pdf (Page 47)

Square Buttonhole

Machine settings

q Pattern: MODE 2: 19

w Thread tension: AUTO

e Presser foot: Automatic buttonhole foot R

r Foot pressure: 5

The size of a buttonhole is automatically set by placing a

button in the rear of automatic buttonhole foot R.

The button holder of the foot takes a button size of 1 cm

(3/8˝) to 2.5 cm (1˝) in diameter.

When selecting the buttonholes, the LCD screen advise

you to lower the buttonhole lever.

NOTES:

It is sometimes necessary to change buttonhole size

to match certain heavy or speciﬁc fabrics and threads.

Make a test buttonhole on an extra piece of the fabric

to check your settings.

The preset width of the buttonhole is suited for

ordinary buttons.

Apply an interfacing to stretch or ﬁne fabrics.

Sewing

z Press the needle up/down button to raise the needle.

Attach the automatic buttonhole foot R snapping the

pin into the groove of the foot holder.

  Youmayliftthepresserfootliftertotheextralifted

position when placing the automatic buttonhole foot

under the foot holder.

q Groove

w Pin

x Pull the button holder to the back, and place the

button in it. Push it together tightly on the button.

e Button holder

c Pull the buttonhole lever down as far as it will go.

y Buttonhole lever

NOTES:

Check the length of the test buttonhole, and adjust the

buttonhole length if necessary by turning the adjusting

screw on the buttonhole foot.

To increase the buttonhole length, turn the adjusting

screw to move the marker toward “L”.

To decrease the buttonhole length, turn the adjusting

screw to move the marker toward “S”.

r Adjusting screw

t Marker

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 91 92

Comments to this Manuals

No comments

JANOME Horizon Memory Craft 8200 QC Instruction Booklet Page 47

Comments to this Manuals

Related products and manuals for Sewing machines JANOME Horizon Memory Craft 8200 QC