JANOME Horizon Memory Craft 12000 Instruction Booklet download pdf (Page 14)

Winding the bobbin

z Pull the thread from the spool.

Hold the thread with both hands and pass the thread

into the guide slot.

q Guide slot

x Draw the thread to the left and forward around the

thread guide.

Draw the thread to the rear and to the right around

and under the guide plate.

Firmly pull the thread to the right while holding it

with both hands.

w Thread guide

e Guide plate

c Pass the thread through the hole in the bobbin from

the inside to the outside.

Turn the power switch on. Put the bobbin on the

bobbin winder spindle.

Push the bobbin to the right.

The LCD screen will show the bobbin winding sign.

r Hole

v Hold the free end of the thread in your hand and

start the machine.

Stop the machine when the bobbin has wound a few

layers, and cut the thread close to the hole in the

bobbin.

NOTE:

Set the speed control slider to the fastest position.

b Start the machine again.

Stop the machine when the bobbin is fully wound

and stops spinning.

Return the bobbin winder spindle to its original position.

Remove the bobbin and cut the thread with the thread

cutter.

t Thread cutter

NOTE:

For safety purposes, the machine will automatically stop

1.5 minutes after starting bobbin winding.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 150 151

No comments

JANOME Horizon Memory Craft 12000 Instruction Booklet Page 14