JANOME JW5622 Instruction Booklet download pdf (Page 11)

Threading the Machine

Raise the take-up lever to its highest position by

turning the handwheel toward you.

Raise the presser foot.

Place a spool on the spool pin as shown, with

thread coming from back of the spool.

Draw the thread into thread guide using both

hands.

While holding the thread near spool, draw

thread down into the tension area and then

around the check spring holder.

Firmly draw the thread up and through the

take–up lever from right to left.

Then draw the thread down and slip it into

needle bar thread guide on the left.

Thread the needle eye from front to back.

NOTE:

You may want to cut the thread end with sharp

scissors for easier needle threading.

Needle Threader

z Raise the needle to its highest position.

Pull down the needle threader knob as far as it

will go.

x Turn the knob in the direction of the arrow in

the illustration, then insert Hook into the needle

eye.

Lead the thread around Guide and under hook.

c Turn the knob in the direction of the arrow in

the illustration, drawing the thread loop through

the needle.

v Pull the thread through the needle eye.

* The needle threader can be used with a #11 to

#16 needle or a Janome Blue tipped needle.

Thread size 50 to 100 should also work well.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

No comments

JANOME JW5622 Instruction Booklet Page 11