JANOME Hello Kitty 13512 Instruction Booklet download pdf (Page 7)

Presser Foot Lifter

The presser foot lifter raises and lowers your

presser foot.

You can raise it about 0.6 cm (1/4˝) higher than

the normal up position for easy removal of the

presser foot or to help you to place heavy fabric

under the foot.

q Lowest position

w Normal up position

e Highest position

To Attach and Remove the Foot Holder

q Thumb screw

w Foot holder

e Presser bar

•Toremove

Remove the thumb screw q by turning it

counterclockwise with a screwdriver.

•Toattach

Match the hole in the foot holder w with the

threaded hole in the presser bar e. Fit the

thumb screw q into the hole. Tighten the screw

q by turning it clockwise with screwdriver.

Changing Presser Foot

q Presser foot

w Groove

e Pin

•Toremove

Turn the handwheel toward you to raise the

needle bar to its highest position.

Raise the presser foot.

Push the toe of the presser foot q to snap it off

the foot holder.

•Toattach

Place the presser foot so that the pin e on the

foot lines up directly below the groove

w of the

foot holder. Lower the foot holder to lock the foot

in place.

CAUTION:

When attaching or removing presser foot, turn

OFF the power switch.

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

No comments

JANOME Hello Kitty 13512 Instruction Booklet Page 7