JANOME 8002D Instruction Booklet download pdf (Page 9)

Raising or Lowering the Presser Foot

By raising or lowering the presser foot lifter, the

presser foot goes up or down.

* While in operation, keep the presser foot lowered

except when threading the machine or test-

running without threads.

Presser foot

2 Presser foot lifter

Changing Needle

Turn off the power switch and unplug the machine.

Raise the needle to its highest position.

Then loosen the left or right needle clamp screw for the

needle you are going to remove.

1 Needle clamp screw on the left

2 Needle clamp screw on the right

* Use HA-1SP #14 Needle or #11.

To attach the needle on the right :

Insert a new needle into the needle clamp with the

flat side to the back until the top of the needle

touches the stopper pin, then tighten the needle

clamp screw on the right.

To attach the needle on the left :

Insert a new needle into the needle clamp with the

flat side to the back until the top of the needle

touches the edge of the needle bar, then tighten the

needle clamp screw on the left.

* When the needles are set correctly, the left

needle is higher than the right one.

* Do not use any needle which is bent or blunt.

Needle clamp

2 Needle

3 Needle stopper pin

4 Edge of needle bar

5 Needle clamp screws

6 Flat side to the back

* Use HA-1SP #14 Needle or #11.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 41 42

No comments

JANOME 8002D Instruction Booklet Page 9