JANOME DC5100 Instruction Booklet download pdf (Page 15)

Flat side

Lado plano

Méplat vers

Needle

Aguja

Aiguille

Changing needle

q Needle clamp screw

w Needle clamp

z Tu rn off the power switch.

Raise the needle to its highest position by turning the

handwheel counterclockwise, toward you, and lowering

the presser foot. Loosen the needle clamp screw q by

turning it counterclockwise. Remove the needle from the

needle clamp w.

x Insert a new needle into the needle clamp w with the

flat side to the rear. When inserting the needle into the

needle clamp w, push it up as far as it goes. Tighten

the needle clamp screw q firmly by turning it clockwise.

c To see if the needle is good, place the flat side of the

needle onto something flat (needle plate, glass, etc.).

The gap between the needle and the flat surface should

be consistent. Never use a bent or blunt needle.

A damaged needle can cause permanent snags or runs

in knits, fine silks and silk-like fabrics.

To remove and attach the foot holder

q Thumb screw

w Foot holder

e Presser bar

•To remove

Remove the thumb screw q by turning it counterclockwise

with a screwdriver.

•To attach

Match the hole in the foot holder w with the threaded

hole in the presser bar e. Fit the thumb screw q into

the hole. Tighten the screw q by turning it clockwise with

a screwdriver.

Changing presser foot

q Snap-on button (red button)

w Groove

e Pin

•To remove

Raise the needle to its highest position by turning the

handwheel counterclockwise. Raise the presser foot, and

press the red button q on the back of the foot holder.

•To attach

Place the selected presser foot so that the pin e on the

foot lies just under the groove w on the foot holder. Lower

the presser bar to lock the foot into place.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Comments to this Manuals

No comments

JANOME DC5100 Instruction Booklet Page 15

Comments to this Manuals

Related products and manuals for Sewing machines JANOME DC5100