JANOME FM725 Use and Care Manual download pdf (Page 25)

Replacing the Light Bulb

WARNING– To reduce the risk of burn:

Turn the power switch OFF and unplug the machine

before replacing the light bulb.

The bulb could be HOT. Protect your fingers when

handling it.

Do not dismantle the machine other than explained in

this section.

1 Remove the cap and setscrew with a screwdriver.

Remove the face plate.

q Cap

w Setscrew

2 Push the light bulb up and twist it counterclockwise

to remove.

e Light bulb

3 Insert a new bulb into the lamp socket. Push the bulb

up and twist it clockwise.

4 Attach the face plate with the setscrew.

Attach the cap to the face plate.

Troubleshooting

Condition

The base

fabric is

punched into

a hole.

The needle

breaks.

The fabric

cannot be

moved

smoothly.

The machine

runs slow

and/or noisily.

The machine

does not run.

Cause

1. Over-punching the

same place

2. The base fabric is too

fine.

1. The needle unit is

incorrectly inserted.

2. The needle is bent or

blunt.

3. The needle clamp screw

is loose.

4. The fabric is pulled or

turned without raising

the needle unit.

1. The height of the

presser foot is too low.

1. Lint and dust have

accumulated inside of

the bed cover and

around needle bar area.

2. The base fabric is too

thick or too dense.

3. The needle is bent or

blunt.

1. The machine is not

plugged in.

Reference

See Page 16.

See Page 12.

See Page 16.

See Page 12.

See Page 22.

See Page 16.

See Page 12.

See Page 10.

1 2 ... 20 21 22 23 24 25 26 27

Comments to this Manuals

No comments

JANOME FM725 Use and Care Manual Page 25

Comments to this Manuals