JANOME FM725 Use and Care Manual download pdf (Page 13)

WARNING– To reduce the risk of injury:

Be sure to turn the power switch off and unplug the

machine before adjusting the presser foot height or

changing the needle unit.

Adjusting the Presser Foot Height

The height of the presser foot should be adjusted

depending on the thickness of materials being punched.

1 Open the finger/eye guard.

2 Lower the presser foot. Loosen the thumbscrew

with the screwdriver.

3 Move the presser foot up or down to match its

height with the total thickness of the material.

4 Tighten the thumbscrew with the screwdriver.

5 Check if the material can be moved smoothly

under the foot.

q Presser foot

w Thumbscrew

e Total thickness of the material

Replacing the Needle Unit

WARNING – To reduce the risk of injury:

Do not use a needle unit if any of the needles are bent

or damaged.

1 Open the finger/eye guard. Loosen the needle clamp

screw with the hexagonal wrench.

2 Pull the needle unit out from the needle clamp.

q Needle clamp screw

WARNING – To reduce the risk of injury:

Close attention is necessary when changing the

needle unit as it has very sharp points and barbs.

3 Insert the new 5-needle unit into the needle clamp

with the flat side facing to the right. Push the needle

unit up as far as it will go.

You can use the single needle unit in place of the

5-needle unit.

w 5-needle unit

e Single needle unit

r Flat side

4 Tighten the screw securely with the hexagonal

wrench.

5 Lower the needle bar slowly to check if each

needle enters into the corresponding needle hole in

the needle plate.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 26 27

No comments

JANOME FM725 Use and Care Manual Page 13