JANOME 49018 Instruction Booklet download pdf (Page 74)

Corded Buttonhole

Machine setting

q Stitch pattern: 09

w Needle thread tension: 1 to 5

e Presser foot: Automatic buttonhole foot: R

z Use the same procedure as the square buttonhole

procedure.

Set the stitch width to match the thickness of the

cord used.

With the buttonhole foot raised, hook the filler cord on

the spur q at the back of the buttonhole foot.

Bring the ends toward you under the buttonhole foot,

clearing the front end.

Hook the filler cord into the forks w on the front of the

automatic buttonhole foot to hold them tight.

Lower the needle into the garment where the

buttonhole will start, and lower the foot.

q Spur

w Forks

x Start the machine and sew the buttonhole.

Each side of the buttonhole and the bartacks will be

sewn over the cord.

Remove the fabric from the machine, and cut the

sewing threads only.

e Needle thread (top thread)

r Bobbin thread (bottom thread)

c Pull the loose ends of the filler cord to tighten it.

Thread the end of the cord through a hand-sewing

needle. Then draw them to the wrong side of the

fabric and knot.

NOTE:

Cut the filler cord at both ends, if the filler cord is

stitched on the fabric and cannot be pulled.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 91 92

No comments

JANOME 49018 Instruction Booklet Page 74