Janome Memory Craft 6500 User Manual download pdf (Page 52)

Button Sewing

Machine Setting

Pattern: 08 (Mode 1)

Thread tension:3-7

Presser foot: Satin stitch foot F

Foot pressure: 3

Feed dog: Dropped

Unthread the needle thread.

Adjust the stitch width so that the needle enters both

holes in the button.

Place a button on the fabric and lower the needle by

turning the handwheel, so that the needle enters into the

left hole in the button.

Align the holes in the button with the slot on the foot and

lower it to hold the button in place.

Turn the handwheel to lower the needle into the right

hole in the button.

Adjust the stitch width if necessary.

Rethread the machine and sew about 10 stitches.

NOTE:

The LCD screen shows a warning to raise the feed dog,

but depress the foot control again to start sewing.

Raise the presser foot and remove the fabric.

Trim both needle and bobbin threads at the beginning.

Cut both threads leaving 20 cm (8”) tails.

Pull the bobbin thread to bring the needle thread to the

wrong side of the fabric then knot the threads.

1 Needle Thread at the Beginning

2 Bobbin Thread

3 Needle Thread

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 77 78

No comments

Janome Memory Craft 6500 User Manual Page 52