JANOME Memory Craft 11000 Special Edition Instruction Booklet Page 91

  • Download
  • Add to my manuals
  • Print
  • Page
    / 112
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 90
92
Stipple quilting with the Acufil design patterns
First sew the center-most pattern of the quilt.
Remove the hoop AQ and quilt layers after the first section
is finished.
NOTE:
To remove the magnetic clamp, tilt and roll it off the frame.
Place the template sheet on the next section to sew and
adjust the position of the template sheet by aligning it with
the first pattern sewn.
Mark the reference lines for the second section.
Set the quilt layers in the hoop AQ and remove pins and
basting stitches from the hooped area.
Attach it to the machine (see the previous page).
NOTE:
Provide a wide space around the machine.
Prevent the free end of the quilt layers from hanging down
from the sewing surface. The use of the optional
clothsetter table is recommended.
Sew the second section. Repeat this step until the entire
area is filled with the stippling pattern.
If you need to sew the quilt upside down, flip the design
pattern in the editing mode after setting the hoop.
If the outer edges of each section do not align with each
otherdue to shrinkage, adjust the pattern size of the outer-
most section.
To adjust the pattern size, select the current pattern again
and press the key to open the single pattern adjusting
window.
Select the dimension or percentage, and press the “+” or
“–” key to adjust the pattern size.
Press the OK key and sew the design pattern in the
adjusted size.
CAUTION:
Make sure the hoop AQ is removed from the carriage
before to the home position. Otherwise the magnetic
clamps may hit the embroidery foot.
NOTE:
For the needle thread, the following brands are
recommended:
• Robison Cotton (50 weight)
• Coats Cotton
• Madeira Polyester (No. 120)
• Sulky Cotton (30 weight)
Reduce the sewing speed for a better result.
1
0
4
7
2
56
9
8
3
60mm
100%
90mm
100%
Adjust Design Dimensions
Page view 90
1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 111 112

Comments to this Manuals

No comments