JANOME 3434D Instruction Booklet download pdf (Page 25)

Adjustment of Cutting Width

When cutting width is too narrow or too wide against

seam width, adjust it as follows.

1. Turn off the power switch and unplug the

machine.

2. Open the looper cover and side cover.

3. Set the upper knife to down position

4. Turn the cutting width adjusting dial to get

desired position of lower knife.

Cutting width adjusting dial

Lower knife

Standard setting

* The cutting width of this model can be adjusted

approximately 3.0 to 5.0 mm from the right needle

position depending upon your sewing needs or the

fabric being used.

(The cutting width should be adjusted to get the

same results as in drawing r.)

(A) When cutting width is too narrow.

Turn cutting width adjusting dial clockwise.

Lower knife will move to right.

(B) When cutting width is too wide.

Turn the cutting width adjusting dial

counterclockwise.

Lower knife will move to left.

5. Set the upper knife to up position.

6. Close the looper cover and side cover.

(A)

(B)

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 86 87

No comments

JANOME 3434D Instruction Booklet Page 25